SDS+ Shank (SRB)
The answer to drilling through concrete-embedded rebar
No longer necessary to relocate holes to avoid rebar; just drill straight through!
Diameters 13/16" and smaller are a 1-piece cutter, and diameters 7/8" and larger are a 2-piece system.
1. When rebar is encountered while drilling, immediately stop and remove the bit from the hole.
2. Mount a rotary rebar cutter in a standard 1/2" drill motor or SDS+ rotary hammer motor (on rotary-only setting), and drill through embedded rebar.
3. Once rebar has been drilled through, remove the rebar cutter, and continue drilling using the masonry bit.
ALL REBAR CUTTERS ARE DESIGNED FOR ROTARY-ONLY OPERATION
Rebar Cutter - SDS+ Shank (1-piece)
Rebar Cutter - SDS+ Shank (2-piece)
Replacement Shanks for DIA. 7/8" and larger
*Supplied with complete saw
Replacement Cutter Heads for DIA. 7/8" and larger
Follow power tool manufacturers' recommendations for bit capacity.
Safety Note: The operator of this tool assumes sole responsibility for any adverse structural effects of cutting rebar. Consult structural engineers if you have any concerns.