STEP 3:

Finish drilling your hole!

Back to Rebar Page

Here's how...

Remove the rotary rebar cutter after the rebar
has been drilled completely through and finish
drilling the hole with the rotary hammer
and hammer bit.

Tips...
  • • ROTARY-ONLY
    • Low Rpm's (without stalling drill motor)
    • Ample operator pressure (without stalling drill motor)
    • Remove steel "slug" from hole or rebar cutter
    • Dry-cut recommended
    • Designed to cut steel
    • Always use a sharp rebar cutter
    • Always use a Relton rebar cutter
    • Always use a Relton masonry bit