STEP 2:

Drill rebar until you just break through...

Remove the rebar cutter from the hole...

Here's how...

Mount a rotary rebar cutter in a standard 1/2" drill
motor or 1/2" hammer-drill (with the selector in the
rotary-only position); insert the rotary rebar
cutter into the hole and drill through the
embedded rebar.

• • ROTARY-ONLY
  • Low Rpm's (without stalling drill motor)
  • Ample operator pressure (without stalling drill motor)
  • Remove steel "slug" from hole or rebar cutter
  • Dry-cut recommended
  • Designed to cut steel
  • Always use a sharp rebar cutter
  • Always use a Relton rebar cutter
  • Always use a Relton masonry bit